Dostępny na zamówienie
This low pass filter is a very good -24dB/octave Moog filter, based on the classic Moog cascade with selected, low-noise transistors
Zakupy z Mode.M Modular są zawsze bezpieczne.
Połączenie z serwerem jest szyfrowane z użyciem klucza SSL
Szybka dostawa kurierem lub paczkomatem
Darmowa dostawa do Polski od 500 PLN
Produkt dostępny na zamówienie
Being the successor of the RS-100, the new "S" version features several improvements regarding stability, tracking, distortion behavoiur and also the frequency range.
24dB/oct low pass filter based on the design by Moog. Two signal inputs, resonance, manually and voltage controlled cutoff frewquency. Frequency range 10Hz to 35kHz with CVs applied.
The transistors used in the filter cascade are low-noise, have been selected ans in addition matched in pairs what improves frequenc response over the whole frequency range.
A better stability guarantees after one minute heating time that the flter can be used as a clean and well tracking sine wave oscillator.
Usage with Eurorack:
/>Analogue Systems' modules are designed solely for use in cases and cabinets made by Analogue Systems. Through the use of adaptors or adaptor cables, however, it is possible to connect them to Eurorack cases.
Should you chose to use an Analogue Systems module in an Eurorack case, please note that the warranties are thus void and the use occurs at your own risk! If the module is plugged in incorrectly and therefore damaged the customer has to bear any costs for repair and shipping!
Because of the different position of the mounting holes there will be a gap of 0.5HP (= 2.5 mm) when mounting an Analogue Systems module next to a Eurorack module. Take this into consideration when planning your system. Gaps can be covered with 1.5HP wide blank panels by Doepfer.
Two audio inputs with level controls. One audio output.
Two cutoff CV inputs: one with fixed 1V/octave, the other is variable
3U module in Analogue Systems form factor, 12HP wide, 64mm deep
30mA power consumption
Weight 0.163 kg